Home Home Home
The StringAmp™ High End Audio Analog Sound Service Links Contact MusikLab
   
 
Essential Audio

 
   
Design
 
   
Speakers

 
   
Amps  


Dansk
 

4 separate gold plated binding posts for bass and treble crossovers enable biwiring og biamping.
 

 

Low loss crossover components, heavy gauge copper inductors and poly prop capacitors.
 
 

EA2 front frame design minimise sound reflections.
 

Essential Audio Speakers



EA2

The Essential Audio loudspeaker EA2W is a 2way bass reflex using exclusive handbuilt loudspeaker elements from Scanspeak. These Scanspeak elements are considered among the very best and are found in highly regarded loudspeaker producers´ top models.

The Scanspeak Revelator 5½" woofer/mid element has been carefully balanced for outstanding clarity of the midrange and a powerful low end Bass extension that handles an engaging and dynamic listening experience.

A Scanspeak´s SD (Symmetric Drive) 28mm silk dome treble matches perfectly , providing a sweet and clear high frequency extension.

Following Musiklab.dk`s proprietory long term break in procedure they sound open and unstrained from the very lowest levels, mastering difficult vocal and instrumental tracks and dynamic peaks. On the aluminum back panel, four sturdy goldplated loudspeaker terminals provide acccess for Biwiring
and Bi amping. They connect to the separate high and low pass heavy gauge crossover circuits that integrate the elements seamlessly over the full audio range. Sensitivity is 87dB , recommended amplifier power is between 20-200W.

The EA2 front frame provides protection to the expensive speaker
elements and is designed to make the speaker appear very
discretely while offering maximum sound transparency, by design
avoiding frame reflections and diffractions.

Despite an enclosure sized as a couple of Office document binders, the bass reproduction is more than ample for all music genres in a mid sized listening room.
The two bassreflex ports are facing to the front, enabling a flexible placement on a stand, on a wall or on a shelf in personal listening environments, and allow for gradual adjustment of the bass response to smaller room acoustics. In the sound studio it is used as a near- to midfield monitor placed on the meter bridge of the mixing desk.
It´s a fact: All loudspeaker elements benefit from a burn in to loosen up. EA2W loudspeakers are delivered ready to perform at their best after burn in, of individual elements using a proprietory procedure of up to 72 hours, after which the elements are measured, matched and fitted in complementary pairs, ready for serious professional qualitative listening.